| Search | Statistics | User Listing | Forums |
| Mitsubishi 380 Forum -Exclusively for owners of the Australian 380 PS41 -> Technical info for the 380 -> Miscellaneous info-heater resistor etc -> View Thread |
|
| You are logged in as a guest. ( logon Only if you have registered by Email as per the instructions in the forum) |
 Crankshaft pulley removal.Jump to page : 1 Now viewing page 1 [10 messages per page] | View previous thread :: View next thread |
| Technical info for the 380 -> Miscellaneous info-heater resistor etc | Message format |
Administrator |
| ||
Frequent flyer Gold Posts: 1092     Location: An island off southern Tasmania. | You can get it off with a simple Allen key if you don't have the pulley tool. make sure that the Allen key is long enought to sit in about the 3 oclock position else it will slip. be gentle, dont jar it else you will break something. If need ne then get a long pipe on the ring spanner. Don't bash it. worked a number of times for me. can also be used to tighten it back up. Use the thickest allen key that you can get to fit. (380 crank bolt removal.jpg) Attachments ----------------  380 crank bolt removal.jpg (182KB - 579 downloads) | ||
| |||
| Jump to page : 1 Now viewing page 1 [10 messages per page] |
| Search this forum Printer friendly version E-mail a link to this thread |
| (Delete all cookies set by this site) | |
