| ||
![]() | ||
|
You are logged in as a guest. ( logon Only if you have registered by Email as per the instructions in the forum) |
![]() Jump to page : 1 Now viewing page 1 [10 messages per page] | View previous thread :: View next thread |
Buy sell swap section -> Youtube links | Message format |
wsbtt![]() |
| ||
Frequent flyer Gold Posts: 421 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Location: Brisbane,qld | For anyone interested, check this out http://www.youtube.com/watch?v=HkPFZWd8wj4&NR=1 Edited by wsbtt 14/8/2011 17:30 | ||
| |||
Administrator![]() |
| ||
Frequent flyer Gold Posts: 1093 ![]() ![]() ![]() ![]() ![]() ![]() Location: An island off southern Tasmania. | Thanks mate...nice video | ||
| |||
wsbtt![]() |
| ||
Frequent flyer Gold Posts: 421 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Location: Brisbane,qld | would a 7-8 psi blower benefit from this mod? | ||
| |||
Administrator![]() |
| ||
Frequent flyer Gold Posts: 1093 ![]() ![]() ![]() ![]() ![]() ![]() Location: An island off southern Tasmania. | wsbtt - 7/9/2011 12:15 would a 7-8 psi blower benefit from this mod? If you aren't strengthening the engine then it is a must to prevent engine damage. | ||
| |||
Godzilla![]() |
| ||
Frequent flyer Silver Posts: 62 ![]() ![]() ![]() | Yeah, no, maybe.... Simple tricks to avoid needing it. Running a higher octane fuel reduces detonation. Running a efficient inter-cooler on turbo setups reduces intake temps. Adding decompression plates under the heads or lower compression pistons reduces detonation. Correctly setting the ignition timing graph, to the selected fuel VS boost will avoid this happening. Its all in the setup, engine build and or tune to optimize the engine performance. I had a boilermaker mate who supercharged a old Datsun 1600, a simple water washer bottle, higher pressure pump than the standard washer bottle little motor and a jet running into his intake piping, all connected up to a micro switch on his carb did the trick for him, he did not need to drop compression ratios and use to leave V8's for dust. | ||
| |||
phaseautos![]() |
| ||
Frequent flyer Silver Posts: 51 ![]() Location: Australia | Running a higher octane fuel reduces detonation. (yes) Running a efficient inter-cooler on turbo setups reduces intake temps. (yes) Adding decompression plates under the heads or lower compression pistons reduces detonation. (yes) Correctly setting the ignition timing graph, to the selected fuel VS boost will avoid this happening. (yes) Its all in the setup, engine build and or tune to optimize the engine performance. (yes) water meth helps but not desired on street cars if you can help it (just as nos works as a power adder due to inconsistencies in fuel and having to refill) (as per water meth) it becomes painful and not so desirable my 2 bob if using water meth have a good level indicator | ||
| |||
Jump to page : 1 Now viewing page 1 [10 messages per page] |
Search this forum Printer friendly version E-mail a link to this thread |
(Delete all cookies set by this site) | |