| Search | Statistics | User Listing | Forums |
| Mitsubishi 380 Forum -Exclusively for owners of the Australian 380 PS41 -> Technical info for the 380 -> 6G75 section -> View Thread |
|
| You are logged in as a guest. ( logon Only if you have registered by Email as per the instructions in the forum) |
 Torque converter drive plateJump to page : 1 Now viewing page 1 [10 messages per page] | View previous thread :: View next thread |
| Technical info for the 380 -> 6G75 section | Message format |
Administrator |
| ||
Frequent flyer Gold Posts: 1093     Location: An island off southern Tasmania. | Removing the securing bolts of drive plate to torque converter is accessed by two 10mm bolts holding a service cover under the starter motor area. You will need a good fitting 17mm socket on the drive plate bolts, you will also need another socket on the harmonic balancer to rotate the plate to get to all the bolts around the circumference. This action needed for engine seperation from transmission. (6g75 drive plate bolts.JPG) (6g75 drive plate bolt access.JPG) Attachments ----------------  6g75 drive plate bolts.JPG (866KB - 630 downloads) 6g75 drive plate bolt access.JPG (815KB - 605 downloads) | ||
| |||
| Jump to page : 1 Now viewing page 1 [10 messages per page] |
| Search this forum Printer friendly version E-mail a link to this thread |
| (Delete all cookies set by this site) | |
