Frequent flyer Gold
Posts: 1093
   
Location: An island off southern Tasmania. | Removing the securing bolts of drive plate to torque converter is accessed by two 10mm bolts holding a service cover under the starter motor area.
You will need a good fitting 17mm socket on the drive plate bolts, you will also need another socket on the harmonic balancer to rotate the plate to get to all the bolts around the circumference.
This action needed for engine seperation from transmission.
 (6g75 drive plate bolts.JPG)
 (6g75 drive plate bolt access.JPG)
Attachments
----------------
 6g75 drive plate bolts.JPG (866KB - 631 downloads)
6g75 drive plate bolt access.JPG (815KB - 606 downloads)
|